Of Mooncursers and other Spun yarns

Of Mooncursers and other Spun yarns
Click the link below and go to my book site
Showing posts with label Phil Bolger. Show all posts
Showing posts with label Phil Bolger. Show all posts

Thursday, February 8, 2007

Sailboats Fair and Fine #31 : read oldest posts first












Here's a couple more boats anchored back at Beaufort. I'm not sure but that black hulled boat may be a "Bill Trip" design. The picture with the little blue hulled boat has a white boat over at the shore. That is the dingy dock there. Your dink needs to be strong enough to bang up against the pilings all day and have everyone climb over it.


Well here we are anchored just off Swansborrow. We anchored under sail and with no power and little wind we hardly pulled the anchor in at all. Last night was not a great night the changing tides had us dragging anchor several times in a crowded anchorage. We had sailed in with the tide running out against the wind so we were barely moving over the bottom so the anchor did not really pull in. I was concerned, but I was not the only one dragging anchor. The wind was up some and the boats ran up to windward then turned sideways and charged down river with the tide sometimes pulling out their anchors and sometimes jerking them around to set upwind again. Woftrap didn't sail on her anchor as some did but when the wind slacked the tide would push her to windward. With an increase in wind she would blow against the tide. The anchorage was a mess with every boat reacting different to the wind and way to close together. So they tried to run all over top each other most of the night.

I wanted to re anchor Wolftrap but it was the middle of the night and boats were every which way and I just couldn't see myself charging back into the anchorage under sail. Finally at day break some boats moved out and made some room. We hoisted sail and hauled in the Anchor and Georgene headed out to the channel with her. She jibed her around and headed back in at a good 4 knots. I dropped one hook and we run on dropping the second anchor snubbing them up and they didn't catch hold. We got the anchors up and headed out again and I dropped the Main and jib so we came in on foresail at about two and a half knots and went through the anchoring thing again and this time they took a good bite.

Fellas Let me tell you something, teach your wife how to handle the boat and let her do it, as much as she will. I have many times seen a one hundred and ten pound women trying to fend a boat off a dock or handle a couple of anchors and tackle with her husband cursing her the whole time. He looks a damn fool and she looks like she would like to throw his fat ass overboard. Let her gently push the throttle back and forth while you haul halyards and anchor rodes you both last longer at boating. Throw a wad of paper in the water and let her doc to it for practice.

Feeling pretty good about Wolftrap staying put this time we crawled back in the bunk and got some real sleep until about Ten A.M.

About noon after and rest I food I unbolted the engine which took about an hour.


Then I took the main sheet off which is double blocked on both ends. I attached the main sheet lower block to the engine. After that I hoisted the main boom up high making a gen pole out of it. I lifted the engine out with the four part main sheet. I less than two hours she was setting on a piece of plywood that at had stowed under a bunk for just some emergency like this one. In about two more hours the clutch was apart and I knew what was needed. We went into the Marina and talked with, Casper, the owner and the parts were ordered and would be there on Monday when the supplier would be coming to Swansboro from Moorehead city.

I rented a slip for a few days not wanting to be in a crowded anchorage without and engine with boats sliding all over the place.

You would be surprised how many people with really fine boats don't know how to anchor. Some drop the anchor and then don't pull it in they just leave it laying on top the bottom. About one A.M. they are dragging all over the anchorage screaming hollering and blowing horns.

If You have an engine it's an easy matter to pull up your anchor and move. If you don't your going to be up fending off fifty thousand pounds of boat that wants to run over top of you.

If you don't and you stay where you are you might as well be married the the guy because you are going to be all over top of each other.

About sundown with the breeze falling light I went in and tied a rope from the forward outside piling to the dock that we would be laying along side. The idea being that if we suddenly got a sail full of wind and came shooting in like a bullet we would either break the rope, pull out the piling or stop our boat. I had a line around an aft cleat and we sailed in under foresail alone. As we came to the end of the dock and dropped the sail. We eased into the slip at about a half knot. I went around the piling with my aft line and brought Wolftrap to a stop. Folks walk down to Casper's Dock about sundown so we had a pretty good audience to either be boat handlers or fools. They took our lines and we got a hand of applause.

An awful lot of the confidence of doing this is a result of Phil Bolsters sail laceing on the mast. It never hangs it always come down quickly and freely and I just can't sing it's praises enough. The other thing is the Top yard is just heavy enough to drop the sail quickly. That is of course if you keep the gaff level while it drops. Let the peak or the throat get ahead and it's like having breaks on it.




Saturday, December 30, 2006

Wolftrap to the Center of the World and Beyond: Read oldest posts first.





Woftrap in a sling: Note the fins on the rudder,very efective. You will see that the rig was changed,now sporting a schooner rig. Note how deep the chine is under the water line. My mistake, she is carrying about a thousand lbs. too much ballast.
Though very fast she would have been faster with less ballast. I had fears that if rolled over she might not right.

A nearby boat builder suggested I talk to Phil Bolger to design the boat. I had never heard of him. He said talk to him, he will understand what you want and what you like and I will guarantee you will be satisfied. All this while we stood looking at, Black Skimmer, which I liked from some angles and hated from others. From the side she looked great from the bow and stern I thought she was God awful ugly. I had seen and sailed on some local sharpies as a kid in Baltimore but none had square sides. I just couldn't look on a square sided boat with any enthusiasm. In my mind you bent a plank around the length of a boat and because it was leaning outward it curved to form the sheer. How could you have sheer with perpendicular sides. Just seemed to me unnatural. The person I was with was Mike O'brian the now editor I believe of Wooden Boat magazine. Mike was building small open boats along about then. At the time I thought his messing with small open boats was a complete waste of time. Like so many things this too has done a complete turn around in my mind. It's a funny thing the whole world has always been way ahead of me.

In those days I had not read a lot of boat building or design books. My experience was pretty much limited to sailing and repairing rot, painting, scraping, and hand stitching old sails. Most lines on my boats were spliced and never thrown away until they looked like squirrels tails. I made baggy winkles out of the remains because I couldn't bring myself to throw them away.

I called Mr.Bolger and talked to him. I was really impressed by our conversation though he didn't agree with me on all my idea's where the kind of boat I needed to build was concerned in order to have what I want and still be able to sell it. He said he had an idea for a boat like I wanted but it would be hard to do in 26 ft. I agreed to 28ft. He convinced me to go with a cat yawl rig as a trial rig. I was given an overwhelming amount of reasons why it would be a better rig, not to mention that the schooner rig was out of fashion and would be hard to sell and he felt that windward ability for a manufactured boat was needed as a selling point. We decided on a cat yawl rig with sprites. She was to have a raised deck with a side profile somewhat in the manner of, Moccasin. Which was a boat I admired but a shape not easily built from aluminum plate.

Sprites were and idea that took a little getting used to. I was in favor of gaff rigged sails. My boat was getting farther and farther away from what I had envisioned and I was beginning to have serious doubts about what kind of design I was going to wind up with. At that point I was about to give up on Mr. Bolger feeling that we were not talking about the same boat at all.

He sent me a couple cartoons of Woftrap and I was really intrigued.

My partners liked what they were hearing from my conversations so I wrote a check and sent it to Mr. Bolger to make up a set of sketches so we could see what he was talking about. I think the sketches were to cost $300 and to be deducted from a total of $1000 if we decided to go with his design.

There was a lot of speculation as to what sort of boat she would look like.

Finally one morning a set of drawings arrived along with a letter. Mr. Bolger's letters are a work of art in themselves. We passed it around the shop and everybody in the place read it. The secretary had to run off a bunch of copies for the fellows in the shop. Reading his letter, my thoughts went to Joshia Slocum there was a kind of similarity to the cadence and rhythm with a bit of a feel of an earlier time and a definite reverence for the modern. Phil Bolger knows how to set the hook I thought.

I reached in the envelope and pulled out the drawings, my hands were actually shaking. I was shocked at her looks I didn't like her much. Her stern was too high, her rudder was funny looking, the off center mizzen almost floored me and to my eye the rig was funny looking.

I called my partners into my office to take a look and they were disappointed. We sat talking reading the letter and studying the drawings. That evening we wound up setting in my office until after midnight. The conversation was more and more in terms of well I like this or that or some other thing. The reason for the odd shape of the rudder became apparent when we realized the tiller came through the top of the transom and being a tiller that could rotate from side to side in order to have it on which ever side the helmsman was on thus eliminating any need for a hiking stick made sense. The mizzen was off center so that the forward mast could be folded back and the mizzen folded forward. The handrails in place of life lines along the forward deck at first looked odd but had began to grow on me as I realized the could be set on or leaned against to steady oneself. And they were big enough in diameter that they would not cut you in half if you fell from one side of the boat to the other. They were also strong. And they did have a traditional look about them. We had all grown more accustomed to the look of the rig but worried that she would not go to windward on one tack with a sprite pushed into the shape of the sail.

Over the weekend I made up a list of things that I liked and things I disliked. The dislikes were now few.

On Monday we all got together and decided we weren't crazy about the rig but that we would try it. There was no doubt by now as to whether we were going to build her or not. We were!

There was some thing still wrong with her looks but none of us could figure out what. Finally I said she is to high sided or slab sided or something like that. They all agreed and we stood looking at her drawing blown up and thumbtacked to the wall.

The old black smith leaned his head around the corner of the door and said. “She don't look right cause she ain't never gonna git built.”

“What the hell you mean Elliot? Where gonna build her,” the company president Bob said with a fare amount of force.

“ No Ya ain't, cause she aint got no chine and ya can't build a boat like her with out no chine.” was Elliott's acid reply.

Well he was right. I picked up a pencil and drew in an imperfect chine about where I thought it ought to go. There it was she was a really handsome hull her high sidedness was gone and she now looked three dimensional and be sides that the gental curve running along her side was quite beautiful.